History

Robin Mueller e30d6d3f22 Some checks failed Rust/va108xx-rs/pipeline/pr-main There was a failure building this commit Details delay works		2024-09-30 11:21:21 +02:00
..
src	delay works	2024-09-30 11:21:21 +02:00
Cargo.toml	something is still wrong	2024-09-27 16:34:53 +02:00
README.md	delay works	2024-09-30 11:21:21 +02:00

README.md

VA416xx Bootloader Application

This is the Rust version of the bootloader supplied by Vorago.

Memory Map

The bootloader uses the following memory map:

Address	Notes	Size
0x0	Bootloader start	code up to 0x3FFC bytes
0x2FFE	Bootloader CRC	word
0x3000	App image A start	code up to 0x1DFFC (~120K) bytes
0x117F8	App image A CRC check length	word
0x117FC	App image A CRC check value	word
0x11800	App image B start	code up to 0x1DFFC (~120K) bytes
0x1FFF8	App image B CRC check length	word
0x1FFFC	App image B CRC check value	word
0x20000	End of NVM	end

Additional Information

This bootloader was specifically written for the REB1 board, so it assumes a M95M01 ST EEPROM is used to load the application code. The bootloader will also delay for a configurable amount of time before booting. This allows to catch the RTT printout, but should probably be disabled for production firmware.

This bootloader does not provide tools to flash the NVM memory by itself. Instead, you can use the flashloader application to perform this task using a CCSDS interface via a UART.

The bootloader performs the following steps:

The application will calculate the checksum of itself if the bootloader CRC is blank (all zeroes or all ones). If the CRC is not blank and the checksum check fails, it will immediately boot application image A. Otherwise, it proceeds to the next step.
Check the checksum of App A. If that checksum is valid, it will boot App A. If not, it will proceed to the next step.
Check the checksum of App B. If that checksum is valid, it will boot App B. If not, it will boot App A as the fallback image.

You could adapt and combine this bootloader with a non-volatile memory to select a prefered app image, which would be a first step towards an updatable flight software.

Please note that you MUST compile the application at slot A and slot B with an appropriate memory.x file where the base address of the FLASH was adapted according to the base address shown in the memory map above. The memory files to do this were provided in the scripts folder.