From 23f2cf5a8ce82b2fb89168cacd29f6faa37cf838 Mon Sep 17 00:00:00 2001 From: Robin Mueller Date: Thu, 23 Dec 2021 14:01:50 +0100 Subject: [PATCH] dont track .cargo/config.toml anymore --- .cargo/config.toml | 38 -------------------------------------- 1 file changed, 38 deletions(-) delete mode 100644 .cargo/config.toml diff --git a/.cargo/config.toml b/.cargo/config.toml deleted file mode 100644 index 731f822..0000000 --- a/.cargo/config.toml +++ /dev/null @@ -1,38 +0,0 @@ -[target.'cfg(all(target_arch = "arm", target_os = "none"))'] -# uncomment ONE of these three option to make `cargo run` start a GDB session -# which option to pick depends on your system -# If the RevA board is used, replace jlink.gdb with jlink-reva.gdb -# runner = "arm-none-eabi-gdb -q -x jlink.gdb" -# runner = "gdb-multiarch -q -x jlink.gdb" -# runner = "gdb -q -x openocd.gdb" -runner = "gdb-multiarch -q -x jlink.gdb" - -rustflags = [ - # This is needed if your flash or ram addresses are not aligned to 0x10000 in memory.x - # See https://github.com/rust-embedded/cortex-m-quickstart/pull/95 - "-C", "link-arg=--nmagic", - - # LLD (shipped with the Rust toolchain) is used as the default linker - "-C", "link-arg=-Tlink.x", - - # if you run into problems with LLD switch to the GNU linker by commenting out - # this line - # "-C", "linker=arm-none-eabi-ld", - - # if you need to link to pre-compiled C libraries provided by a C toolchain - # use GCC as the linker by commenting out both lines above and then - # uncommenting the three lines below - # "-C", "linker=arm-none-eabi-gcc", - # "-C", "link-arg=-Wl,-Tlink.x", - # "-C", "link-arg=-nostartfiles", -] - -[build] -# Pick ONE of these compilation targets -# target = "thumbv6m-none-eabi" # Cortex-M0 and Cortex-M0+ -# target = "thumbv7m-none-eabi" # Cortex-M3 -# target = "thumbv7em-none-eabi" # Cortex-M4 and Cortex-M7 (no FPU) -target = "thumbv7em-none-eabihf" # Cortex-M4F and Cortex-M7F (with FPU) -# target = "thumbv8m.base-none-eabi" # Cortex-M23 -# target = "thumbv8m.main-none-eabi" # Cortex-M33 (no FPU) -# target = "thumbv8m.main-none-eabihf" # Cortex-M33 (with FPU) \ No newline at end of file