va416xx-rs/va416xx-hal/.cargo/def-config.toml
Robin Mueller 5d1740efea
All checks were successful
Rust/va416xx-rs/pipeline/head This commit looks good
Init Commit
Monorepo for Rust support of VA416XX family of radiation hardened MCUs
2024-06-25 20:01:21 +02:00

39 lines
1.7 KiB
TOML

[target.'cfg(all(target_arch = "arm", target_os = "none"))']
# uncomment ONE of these three option to make `cargo run` start a GDB session
# which option to pick depends on your system
# If the RevA board is used, replace jlink.gdb with jlink-reva.gdb
# runner = "arm-none-eabi-gdb -q -x jlink/jlink.gdb"
# runner = "gdb-multiarch -q -x jlink/jlink.gdb"
# runner = "arm-none-eabi-gdb -q -x jlink/jlink-reva.gdb"
# runner = "gdb-multiarch -q -x jlink/jlink-reva.gdb"
rustflags = [
# This is needed if your flash or ram addresses are not aligned to 0x10000 in memory.x
# See https://github.com/rust-embedded/cortex-m-quickstart/pull/95
"-C", "link-arg=--nmagic",
# LLD (shipped with the Rust toolchain) is used as the default linker
"-C", "link-arg=-Tlink.x",
# if you run into problems with LLD switch to the GNU linker by commenting out
# this line
# "-C", "linker=arm-none-eabi-ld",
# if you need to link to pre-compiled C libraries provided by a C toolchain
# use GCC as the linker by commenting out both lines above and then
# uncommenting the three lines below
# "-C", "linker=arm-none-eabi-gcc",
# "-C", "link-arg=-Wl,-Tlink.x",
# "-C", "link-arg=-nostartfiles",
]
[build]
# Pick ONE of these compilation targets
# target = "thumbv6m-none-eabi" # Cortex-M0 and Cortex-M0+
# target = "thumbv7m-none-eabi" # Cortex-M3
# target = "thumbv7em-none-eabi" # Cortex-M4 and Cortex-M7 (no FPU)
target = "thumbv7em-none-eabihf" # Cortex-M4F and Cortex-M7F (with FPU)
# target = "thumbv8m.base-none-eabi" # Cortex-M23
# target = "thumbv8m.main-none-eabi" # Cortex-M33 (no FPU)
# target = "thumbv8m.main-none-eabihf" # Cortex-M33 (with FPU)