27 lines
1.6 KiB
ReStructuredText
27 lines
1.6 KiB
ReStructuredText
|
Network Topology
|
||
|
================
|
||
|
|
||
|
CSP uses a network oriented terminology similar to what is known from the Internet and the TCP/IP model. A CSP network can be configured for several different topologies. The most common topology is to create two segments, one for the Satellite and one for the Ground-Station.
|
||
|
|
||
|
.. code-block:: none
|
||
|
|
||
|
I2C BUS
|
||
|
_______________________________
|
||
|
/ | | | \
|
||
|
+---+ +---+ +---+ +---+ +---+
|
||
|
|OBC| |COM| |EPS| |PL1| |PL2| Nodes 0 - 7 (Space segment)
|
||
|
+---+ +---+ +---+ +---+ +---+
|
||
|
^
|
||
|
| Radio
|
||
|
v
|
||
|
+---+ +----+
|
||
|
|TNC| ------- | PC | Nodes 8 - 15 (Ground segment)
|
||
|
+---+ USB +----+
|
||
|
|
||
|
Node 9 Node 10
|
||
|
|
||
|
The address range, from 0 to 15, has been segmented into two equal size segments. This allows for easy routing in the network. All addresses starting with binary 1 is on the ground-segment, and all addresses starting with 0 is on the space segment. From CSP v1.0 the address space has been increased to 32 addresses, 0 to 31. But for legacy purposes, the old 0 to 15 is still used in most products.
|
||
|
|
||
|
The network is configured using static routes initialised at boot-up of each sub-system. This means that the basic routing table must be assigned compile-time of each subsystem. However each node supports assigning an individual route to every single node in the network and can be changed run-time. This means that the network topology can be easily reconfigured after startup.
|
||
|
|