TCS observability

mission/controller/ThermalController.h

@@ -26,80 +26,6 @@
 #include <list>
 #include <optional>
 
-/**
- * NOP Limit: Hard limit for device, usually from datasheet. Device damage is possible lif NOP limit
- * is exceeded.
- * OP Limit: Soft limit. Device should be switched off or TCS controller should take action if the
- * limit is exceeded to avoid reaching NOP limit
- */
-struct TempLimits {
-  TempLimits(float nopLowerLimit, float opLowerLimit, float cutOffLimit, float opUpperLimit,
-             float nopUpperLimit)
-      : opLowerLimit(opLowerLimit),
-        opUpperLimit(opUpperLimit),
-        cutOffLimit(cutOffLimit),
-        nopLowerLimit(nopLowerLimit),
-        nopUpperLimit(nopUpperLimit) {}
-  float opLowerLimit;
-  float opUpperLimit;
-  float cutOffLimit;
-  float nopLowerLimit;
-  float nopUpperLimit;
-};
-
-struct ThermalState {
-  uint8_t noSensorAvailableCounter;
-  // Which sensor is used for this component?
-  uint8_t sensorIndex = 0;
-  // Is heating on for that thermal module?
-  bool heating = false;
-  // Which switch is being used for heating the component
-  heater::Switch heaterSwitch = heater::Switch::NUMBER_OF_SWITCHES;
-  // Heater start time and end times as UNIX seconds. Please note that these times will be updated
-  // when a switch command is sent, with no guarantess that the heater actually went on.
-  uint32_t heaterStartTime = 0;
-  uint32_t heaterEndTime = 0;
-};
-
-struct HeaterState {
-  bool switchTransition = false;
-  HeaterHandler::SwitchState target = HeaterHandler::SwitchState::OFF;
-  uint8_t heaterSwitchControlCycles = 0;
-  bool trackHeaterMaxPeriod = false;
-  Countdown heaterOnPeriod;
-};
-
-using HeaterSwitchStates = std::array<HeaterHandler::SwitchState, heater::NUMBER_OF_SWITCHES>;
-
-enum ThermalComponents : uint8_t {
-  NONE = 0,
-  ACS_BOARD = 1,
-  MGT = 2,
-  RW = 3,
-  STR = 4,
-  IF_BOARD = 5,
-  TCS_BOARD = 6,
-  OBC = 7,
-  // Not used anymore, was identical to OBC module.
-  LEGACY_OBCIF_BOARD = 8,
-  SBAND_TRANSCEIVER = 9,
-  PCDUP60_BOARD = 10,
-  PCDUACU = 11,
-  PCDUPDU = 12,
-  PLPCDU_BOARD = 13,
-  PLOCMISSION_BOARD = 14,
-  PLOCPROCESSING_BOARD = 15,
-  DAC = 16,
-  CAMERA = 17,
-  DRO = 18,
-  X8 = 19,
-  HPA = 20,
-  TX = 21,
-  MPA = 22,
-  SCEX_BOARD = 23,
-  NUM_ENTRIES
-};
-
 class ThermalController : public ExtendedControllerBase {
  public:
   static constexpr uint8_t SUBMODE_NO_HEATER_CTRL = 1;