readme update

This commit is contained in:
Robin Müller 2020-10-13 13:43:47 +02:00
parent b9f8798538
commit 3af98f2025

View File

@ -65,14 +65,12 @@ make clean -j
### Build and flash instructions
1. Right click on the arduino folder inside the tree view on the left and go to Preferences. Go to the Arduino section and make sure the Arduino Board Selection tab is configuredcorrectly. Please note that board libraries and libaries need to be installed and added as beforehand as specified in Prerequisites. It is recommended to go to the Compile Options tab and addding
1. Right click on the arduino folder inside the tree view on the left and go to Preferences. Go to the Arduino section and make sure the Arduino Board Selection tab is configuredcorrectly. Please note that board libraries and libaries need to be installed and added as beforehand as specified in Prerequisites. It is recommended to go to the Compile Options tab and addding following define to `to append to C and C++`
```sh
-DSERIAL_RX_BUFFER_SIZE=256
```
to append to C and C++
2. An Arduino like bar can be seen at the top, which can be used to compile the software and flash it to the board. The check symbol is used to compile while the right arrow symbol is used to flash the software. There are also symbols to open the serial monitor or the serial plot.
3. The serial monitor can be opened in the Serial monitor view tab at the bottom or with the icons at the top bar. Take care to pick the correct USB port and baud rate.